Flytec 6015 * Manuel d'utilisateur Page 26

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 36
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 25
Operation Manual Flytec 6015-GPS 24
3.4.3.3 Competition Route – Data display for task Exit Cyl.
) - 00:02:16
v-Req 26.0
Dist.Cyl
Time left display (Count Down) until
Start Time 0:00, then (+) time since
Start
Required speed to reach the
Start Cylinder at Start Time 0:00 *
Distance to cylinder
in Km
Pilot inside of Start Cylinder, Navigation arrow points to next WP
Pilot outside of Start Cylinder, (wrong side) Navigation arrow points back to Start Cylinder
Pilot inside of the cylinder, correct side )
Pilot outside of the cylinder, wrong side ) (symbol flashing)
*Remark:
the required speed is only displayed, if one is present in the 90° segment to the next WP.
3.4.3.4 Competition Route - Data display for task Enter Cyl.
Display as for Exit Cyl. with the difference that the symbol is flashing inside of the cyl., if one is
present inside (on the wrong side). The distance to cylinder and the required speed are always
displayed, as long as one is flying outside of the Start cylinder.
3.4.3.5 Approaching a WP Cylinder
The GPS-Receiver of the IQ-BASIC-GPS calculates its new position every second, therefore
it takes only this one second to inform the pilot about his crossing of the turning point of cylinder
circumference. In this case a long, unmistakable tone sounds during 2 sec. signalling „Waypoint
reached“ and the instrument automatically skips forward to the next Waypoint of the Route.
Irrespective of which recording interval for saving is used during a standard flight, it is in any
case ensured that several Tracklog points are saved every second in the memory of the
IQ-BASIC-GPS when crossing the cylinder circumference.
Remark:
in order to facilitate the decision to peel off, the user field „Dist Cyl“ displays the
distance to the radius of active Waypoint cylinder.
3.4.3.6 Waypoints - skip / backspace
In the window Routes (prolonged pressure on the Route
key) it is possible to skip by use of the arrow key to the
previous waypoint and with the arrow key to the next
waypoint. Upon pressing one of the arrow keys, the
Information field shall display the last, the current and the
next Waypoint.
Position indicator in Start Cylinder
(inside which segment one is flying)
>Haldigrat
>Stanserhorn
>Pilatus
Flight optimisation
Vue de la page 25
1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 35 36

Commentaires sur ces manuels

Pas de commentaire