Flytec 6015 * Manuel d'utilisateur télécharger pdf (Page 28)

Operation Manual Flytec 6015-GPS 26

3.5.5 Relocating thermals



With weak or widely dispersed thermals this function helps to relocate

any lost thermals. A small arrow pointing up in

the compass rose

shows the direction to the last thermal with at least a 1 m/s climb rate.

If this arrow is positioned at the top of the display, one is flying

towards the thermal, however, if it is at the bottom of the display,

one is flying away from the upwash.

In order to use this function, the indicator page"Dist Therm" should in addition be activated.

This

value indicates the distance from the pilot to the last thermal.

The threshold to which the arrow should be pointed can be set under Main Setup Menu



Variometer



Thermal threshold from 0.5 up to 3m/s.

Therefore the arrow is not pointing directly to the centre of the thermal, but to its circumference,

as one needs to relocate the entry area.

4 Flight-Memory and Flight-Analysis

4.1.1 Flight logbook and Flight Analysis

The recording mode does not need to be specifically activated. Each flight is automatically saved.

The flight memory provided with the 6015-GPS not only records flight altitude but it also logs the

position and the GPS-altitude

of the pilot in the WGS84-coordinate system.

In Main Setup Menu



Fight memory



Rec.Intervals it is possible to set the recording

interval. The selected value determines the time interval in seconds according to which a new

data set is entered into the memory. The lowest value is 1 second, which corresponds to a

recording time of approx. 4 hours. At the maximum value of 60s

interval, the recording time

will add up to approx. 291 hours

For the normal OLC recording the Rec.Interval is recommended to be between 5 and 10sec.

Hereby also narrow curves are well recognisable and the number of data points for the external

calculation of the OLC points is kept conveniently clear.

Factory setting is 10 sec.

For the start of a flight the following agreement is applicable:

: :

2 3416

ALT1

2634

FLIGHTTIM

Flight 1/12

15.06.09

14:35:08

-26

m/s

Start is recognised as soon as groundspeed reaches

for at least 5sec. more than 10km/h or if altitude difference

of more than 30m was detected within 60sec., or the Vario

value higher than 1,5 m/s during at least 5sec. was performed.

In each case the previous flight history covering 5 minutes

before take-off is logged into the memory of the

6015- GPS.

The end of the flight is recognised in automatic recording

mode, if less than 10km/h GPS-speed or air speed was

detected during min. 60sec. and also no Vario higher than +/-

0.1m/s was performed.

The instrument displays automatically the flight analysis page

after end of the flight. By brief pressure on the ESC key, or

after 30sec. the instrument shall be switched-off automatically!

Tip: if during display of flight analysis page the OK key

is actuated, the device is not switched-off but returns to

normal operation mode.

Caution:

make sure before take-off that the GPS-Receiver indicates to receive at least 4 Satellites

and that the GPS symbol is displayed.

Begin of the recording is visible by the running „Flight time“- counter or the REC symbol above the

satellite indicator.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 34 35 36

Commentaires sur ces manuels

Pas de commentaire

Flytec 6015 * Manuel d'utilisateur Page 28

Commentaires sur ces manuels

Produits connexes et manuels pour Capteurs Flytec 6015 *