Flytec 6015 * Manuel d'utilisateur télécharger pdf (Page 31)

Operation Manual Flytec 6015 29

7 Miscellaneous

8 Batteries

2x Type AA, 1.5V Alkaline or 2x Type AA 1.2V NiMh Accum.

Operating time with 2 Alkaline batteries is more than 40 hours.

8.1 Batterie charge state

Upon switch-on of the instrument, the actual charge state of the batteries is displayed

on the start-up display screen.

As long as the instrument is operative, the charge state is continuously monitored and is

indicated with the corresponding symbol on the display screen.

empty

half-full

full

8.2 Battery replacement

Replace batteries only, when the instrument is switched-off!

The correct battery type needs to be set under Main Setup Menu

⇒

Instr.sett.

⇒

Battery type.

A wrongly entered setting may lead to the result of the instrument’s premature switch-off

and thus provides incorrect status information!

We recommend not to use NiCd Accumulators.

These batteries have significantly reduced capacity

and they are less environment-friendly.

Also the switching threshold is not laid-out for NiCd Accum.

Remark:

the estimated operation time as mentioned before is based on normal temperatures

of approx. 20 – 25 °C.

At low temperatures the batteries and accumulators have a markedly shorter service life.

In case of prolonged non-use, the batteries should always be removed!

Defective batteries may damage the instrument by leaking acid!

Corrosion damage caused by defective batteries is not covered by the warranty!

1 2 ... 26 27 28 29 30 31 32 33 34 35 36

Pas de commentaire

Flytec 6015 * Manuel d'utilisateur Page 31