Flytec 6015 * Manuel d'utilisateur télécharger pdf (Page 25)

Operation Manual Flytec 6015 23

3.4.3 Competition - Start

For a competition is normally ruled a start cylinder of the EXIT type (flying out of the cylinder)

or ENTER type (flying into the cylinder) and one, or several possible start times (Startgates).

Conditions for a validated start:

After start time release, when the start time (0:00) is attained or exceeded, for:

1. Start mode EXIT, the pilot must show a position inside of the start cylinder.

2. Start mode ENTER, the pilot must show a position outside of the start cylinder.

(If several Start Gates are admitted, each as from the respective Gates Time 0:00).

3.4.3.1 EXIT / ENTER Cylinder

WP2

WP1

Start Cylinder

(ENTER)

WP3

WP1

Start Cylinder

(Exit)

WP2

WP3

Example EXIT Example ENTER

3.4.3.2 Comp. Route Start signals

The „Start time zero signal“ sounds as soon as the start time „Count Down“ attains 0:00 .

The Start OK signal only sounds, when the pilot is present after the start release  Start time

0:00 or later:

1. Exit Cylinder Start  inside of the cylinder.

2. Enter Cylinder Start  outside of the cylinder.

After the Start OK Signal the next active Waypoint is enabled, in this case Waypoint 2.

All navigation related indicator calculations and the directional arrow point to Waypoint 2.

If the pilot decides to take the next Start Gate, he must again select the first WP in the Routes

function (long pressure on the Route key) by scrolling up to this item with the ▲ key.

The instrument activates again WP1 (Start Cylinder) and resets the start time higher  according

to the entered difference. The start time is displayed on the time screen page with St:xx:xx.

When the last Start Gate has been reached, the start time is no longer incremented.

Remark:

In the case of Exit-Cylinder the first Waypoint after the start cylinder must be outside of the

Start Cylinder!

In the case of ENTER-Cylinder the first Waypoint after start cylinder must be

inside of the start cylinder and typically in the centre of the start cylinder!

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 35 36

Pas de commentaire

Flytec 6015 * Manuel d'utilisateur Page 25