Flytec 6015 * Manuel d'utilisateur télécharger pdf (Page 12)

Operation Manual Flytec 6015-GPS 10

2.1.2 Altimeter display Alt2

Shifting between display screens Alt1 and Alt2 is performed by briefly

pressing the key Alt1/Alt2.

The following values can be displayed on the altimeter screen ALT 2:

GPS Alt. = display of GPS altitude

Flight-Level = Flightlevelaltitude in ft relatingto 1013 hPa e.g. display Fl 14 stands for being in

Flight Level 1400 ft ( display in steps of 100 ft )

ALT1 m/ft-Inv = display of altitude ALT1 inverse to unit of ALT1 in ft or m

Relative = the relative altimeter displays altitude with reference to a point.

Altitude setting of this point of reference can be set in A2 set mode at

anytime.

2.1.2.1 Manual setting of altimeter Alt2 (A2 relative mode)

Prolonged pressure on the ALT2 key during ALT2-display activates the instrument into

setting mode.

By briefly pressing one arrow key the display indicator can be adjusted meter by meter.

The displayed value is changed automatically as long as the key is pushed until it is

released.

Tip: the relative altimeter can be used for example for measuring the superelevation above

landing site. For this purpose ALT2 will be reset to zero related to the landing site altitude.

2.1.2.2 Altimeter display Alt2 - definition

Altimeter A2 mode can be defined in the menu (Main Setup Menu



Instrument Settings



Alt2 mode).

Tip: in altimeter display screen ALT2 altitude ALT1 can be selected in ft (inverse to unit ALT1

in m). This information may be of importance when being in contact with the air traffic controller of

Restricted Areas (CTR’s).

2.1.3 Altimeter display Alt3 (differential altimeter)

Altimeter Alt3 is in any case a differential altimeter. It indicates always the difference in regard

to the altitude value on which it has been reset to zero for the last time. This function is often

required to measure the elevation above the start site, or to detect easily during the flight in a

weak thermal the height gain – or loss.

Example: altitude ALT3 is set automatically to 0 m at start site, after take-off the altitude

display Alt3 shall always indicate the altitude above start site.

Reset altitude ALT3 to 0m

By brief pressure on the CLR ALT3 key the altitude ALT3 may be reset to 0m at any time.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 35 36

Pas de commentaire

Flytec 6015 * Manuel d'utilisateur Page 12