Flytec 6015 * Manuel d'utilisateur télécharger pdf (Page 14)

Operation Manual Flytec 6015-GPS 12

2.2.4 Menu Settings Variometer

Tip:

By use of the PC Software Flychart Extras -> Flight instrument Options, all instrument

characteristics can be set easily and comfortably.

By use of the feature tone simulation the adjusted values can be checked easily!

2.2.4.1 Digital-Vario Integrator

Main Setup Menu



Variometer



Digital

Setting of average value time constant from 1 – 30 seconds for the digital Variometer display.

2.2.4.2 Threshold value last thermal

Main Setup Menu



Variometer



Threshold for the display arrowhead of last thermal, the range can be set between 0,5 up to 3 m/s.

The thermal arrowhead in the compass rose points to the direction, where the integrated Vario was

the last time higher than this threshold value.

2.2.4.3 Basic filter (Turbulence filter)

Main Setup Menu



Variometer



Filter .

The response characteristics of Variometer display and of climb- or sink acoustics can be adapted

within a wide range in accordance to the pilot’s needs or the weather conditions.

In order to simplify the settings, Flytec has defined 4 basic- resp. turbulence filters.

Variometer - sensitivity / response characteristics

Filter No.

0 weak filtering

for very calm air in Winter

1 Default normal filtering

for enjoyment thermal with light turbulence

2 high filtering thermal with turbulence

3 very high turbulence filtering

for very rough and strong thermal

2.2.5 Variometer - Acoustic settings

The climb tone is a frequency modulated beep tone whose pitch and beep tone sequence rises

rhythmically at increasing climb rate. The pulse/pause ratio is 1:1.

Following settings are possible under Main Setup Menu



Variometer Climb Acoustic and

Variometer Sink Acoustic:

Climb Acoustic settings:

Climb threshold: = climb acoustic threshold

Basic frequency = basic tone pitch Vario climb

Frequency change = increase of tone pitch

(frequency modification per m/s)

Pitch modification = increase of beep interval per m/s

Pitch mode = linear or exponential

increase of climb acoustic

Pre-Thermal Threshold: = trigger point of Pre-Therm.acoustic

Soundloss

range

Pre Thermal

threshold

Sinktone

threshold

Climb tone

Climb accou.

threshokd

Sink

tonealarm

Sinken

Steigen

0 m/s

Sink Acoustic settings:

Sink threshold: =Sink tone threshold

Basic frequency =basic tone pitch Vario sink

Sink Alarm =Sink alarm threshold

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 35 36

Commentaires sur ces manuels

Pas de commentaire

Flytec 6015 * Manuel d'utilisateur Page 14

Commentaires sur ces manuels

Produits connexes et manuels pour Capteurs Flytec 6015 *